Help Center/NFTs & the Explorer/Turn the explorer's simulated devnet activity on or off (admin)
NFTs & the Explorer•Last updated: 2026-10-19•3 min read

Turn the explorer's simulated devnet activity on or off (admin)

Make the Explorer show generated, clearly labelled devnet blocks and transactions so the network looks alive, or switch them off again.

Have questions or need step-by-step guidance on this topic?

Ask AI Copilot

Step-by-Step Procedure

1

Open the indexer page

Go to Admin, then Explorer, then "Indexer State & Engine" (/admin/explorer/indexer).

2

Find the "Simulated devnet activity" panel

It sits above the indexer figures. The line starting "Status:" says ON or OFF and, when on, how many simulated blocks, transactions and NFT transfers are held.

3

Switch it on

Click "Turn simulation on". The panel confirms that simulated devnet activity is now on. The setting is saved, so it survives a restart.

💡 Pro Tip: Simulated rows live on their own network, "I8 Simulated Devnet", use only simulated addresses, and are excluded from every real total, balance, supply, holder and reconciliation figure.
4

Switch it off

Click "Turn simulation off". Every simulated row disappears from the Explorer immediately. If the server has the environment variable I8_EXPLORER_SIMULATION=true, the panel says simulation stays on regardless of this switch.

Expected Operational Outcome

While on, the Explorer shows a banner "I8 Simulated Devnet - not mainnet" and every simulated row carries a "Simulated devnet" badge. While off, nothing simulated is shown.

Troubleshooting & Failure Modes

Symptom: The buttons are greyed out
Likely Cause: Turn simulation on is disabled when the admin setting is already on; Turn simulation off is disabled when it is already off.
Resolution: Use the other button, or press Refresh at the top of the page.
Symptom: Simulation stays on after Turn simulation off
Likely Cause: The environment variable I8_EXPLORER_SIMULATION=true is set on the server.
Resolution: Remove that variable from the server environment; the panel shows a note while it is set.

Was this guide helpful?

Help us refine our platform documentation