Help Center/Governance, RBAC & Security Desk/Run and filter the Data Integrity scan
Governance, RBAC & Security Desk•Last updated: 2026-10-20•5 min read

Run and filter the Data Integrity scan

Data Integrity Diagnostics compares displayed metrics with stored data. Each check reports OK, WARN or FAIL with a sample of offending rows.

Have questions or need step-by-step guidance on this topic?

Ask AI Copilot

Step-by-Step Procedure

1

Open the page

Open "Control Plane" then "Data Integrity Diagnostics". The scan runs when the page loads.

2

Read the totals

"Checks run", "Clean", "Warnings" and "Offending rows".

3

Filter

Click a severity chip (All severities, OK, WARN, FAIL) and a domain chip. The two filters combine.

4

Read a check

Each card has a title, description, rows examined, a severity chip and either "No offending rows." or a table of up to 50 offending rows.

5

Re-scan

Click "Re-scan" to run the checks again. Use "Control Center" (top left) to go back.

6

Read the metric registry

The panel "Registered metric surface" lists each metric, its source of truth, endpoint, scope and zero policy.

Expected Operational Outcome

You see which stored data disagrees with what the UI displays and can follow up on the offending rows.

Troubleshooting & Failure Modes

Symptom: An error block instead of results
Likely Cause: The scan failed; the page says so rather than pretending the data is consistent.
Resolution: Click "Re-scan" or check "Service Health".

Was this guide helpful?

Help us refine our platform documentation